Method of use:

• The surface must be clean, free of grease and dirt
• Dampen the substrate generously with water before applying the foam, use upside down
• The can should be at room temperature
• Shake the can vigorously about 30 times before starting work
• Screw on the gun and adjust the nozzle
• Fill the working space from the bottom in a zigzag motion (from wall to wall), filling it only partially (approx. 70%) and leaving room for the expanding foam
• Jhe foam layer should not be thicker than 3 cm.
• Once fully cured, remove excess foam with a sharp knife and protect from UV light e.g. with silicone, plaster
• Clean the gun and the hose with a cleaner (available in our offer: Foam Cleaner STINGER)

• Sealing when installing wooden and aluminum elements exposed to large fluctuations in temperature and humidity, e.g. in wooden houses and frame structures
• Sealing, soundproofing and filling elements exposed to vibrations and mechanical pressure, i.e. steps of stairs, partition walls
• Thermal insulation of water, sewage and central heating systems
• Filling gaps in thermal insulation when insulating buildings, with particular emphasis on elements susceptible to deflection and deformation

• Available capacity: 750ml
• Working temperature (substrate): +5 to 30 degrees
• Can temperature: +20 degrees recommended
• Thermal resistance (after curing) from -50 to +90 degrees
• Flammability B3
• Surface curing time: 5-10 minutes
• Full curing time: 24 hours
• Capacity: up to 45 liters (depending on temperature and air humidity)

• Keep out of reach of children
• Avoid contact with eyes and skin
• Use in well-ventilated areas
• Do not breathe product vapours
• Do not use naked flames when using the product